Adjustable hold-down clampand boring head are pneumatically controlled by a foot pedal to keep operator's hands free
Fabricated steel cabinet has bolt-down feet for operating stability
See-thru guard protects from flying woodchips
Heavy cast-iron table features dovetailed miter gage slots for keeping miter gage secured when locked in place - Also with standard-equipped stock stop for operations that require repetitive drilling
Loosening the nuts just before the boring head allows the operator to quickly adjust the depth stopfor final drilling depth - Guide rails are concealed inside flexible rubber tubing for protection against dust and chips
Tough cast-iron table is mounted on dovetail ways with an adjustable gib - The four bolts located on the right-hand side may be adjusted to compensate for wear
Aluminum Boring Head contains two adjustable spindles
Adjustable feed rate knob controls boring speed at which the drill bits enter the workpiece
Easy-to-read scales and reference lines for accurate setting - Convenient grease fitting accepts standard grease gun for lubricating boring head
Built-in chip chut directs dust and debris away from machine
Cast-iron carriage supports motor and boring head
Specs
Horse Power: 1 HP
Motor: 1HP, 3450 rpm, 115/230V, 60 Hz., single phase
Spindle: Accepts 7/16" - 14 RH TPI
Maximum Bit Diameter with Spindles at 3/4" on Center: 5/8"
Drill Stroke (Carriage Stroke): 3 7/8"
Minimum/Maximim Center Distance of Spindle: 3/4" to 3"
Air Requirement: 90 PSI
Motor Speed: 3450
Table Travel to Center of Bit: 3 1/2"
Maximim Material Thickness (Table to Guard): 8 1/2"
