Call Toll Free
2.8 / 5
Reviews
"Great product!" Submitted on September 28th, 2008
5
5
5
Pros: Handy set, beats carring bits and taps
Cons: none that I can find
Comments:
This is one handy set. I've read the comments about not being able to drill thicker material but disagree with that. I have used them for 1/8" and 3/16" material with no problem. If you you go much over that, you might want to resort to a traditional drill and tap. As an electrician, most of the places where we would use these would typically be 1/8" and under and they are great time savers.
Average Rating: 5
Features
5
Performance
5
Value
5
Pros: Handy set, beats carring bits and taps
Cons: none that I can find
Comments:
This is one handy set. I've read the comments about not being able to drill thicker material but disagree with that. I have used them for 1/8" and 3/16" material with no problem. If you you go much over that, you might want to resort to a traditional drill and tap. As an electrician, most of the places where we would use these would typically be 1/8" and under and they are great time savers.
"Very Disappointed" Submitted on October 19th, 2007
3
1
1
1
Pros: Good Concept
Cons: Read Comments
Comments:
I have always been a fan of Greenlee products, but this product is far from good. the main problem that i had with these taps is that you cant tap anything over 1/16th of an inch. the drill part of the bit should be a little longer so that you dont start tapping when you arent through the metal, another thing is that the neck of the bit is too weak. ive had 6 of the 1/4 20 bits and went through them in a weak because they kept snapping
Average Rating: 1.5
Features
3
Performance
1
Reliability
1
Value
1
Pros: Good Concept
Cons: Read Comments
Comments:
I have always been a fan of Greenlee products, but this product is far from good. the main problem that i had with these taps is that you cant tap anything over 1/16th of an inch. the drill part of the bit should be a little longer so that you dont start tapping when you arent through the metal, another thing is that the neck of the bit is too weak. ive had 6 of the 1/4 20 bits and went through them in a weak because they kept snapping
